This website uses cookies. By continuing to use this site you are agreeing to our use of cookies. Privacy Policy

How to paint Dark Angels

Here it is!

After much work on the part of Fabalah, who does all the photos, the next tutorial is finally up. I would also like to extend a warm welcome to Eye of Error, a new member of the Artisan Alliance. So let’s get started!

Here are all the paints I used in this tutorial. The dark grey at the top left is the old Adeptus Battlegrey, and the metallics in the middle are P3 Pig Iron, Cold Steel, Molten Bronze, and Rhulic Gold. I should mention that the only paint not shown here is Blazing orange, which I forgot to add to the pile.


Step I
First, you’re going to want to prime the mini black. You can use white or grey, but this will brighten any colors you do.

Step II
Basecoat all of the armour with Caliban Green.

Step III
Begin layering with a 2:1 mix of Caliban Green and Warpstone Glow. For this step, I chose to apply the paint in areas the sun would hit, and leave Caliban Green in the shadows.

Step IV
Highlight the armour with Warpstone Glow. Add some water for this step, as you want to make sure the paint goes on smooth.

 Step V
This is the final stage for the green. Take some black paint (I use Matt Black from Army Painter) and shade between the armour sections. Be sure to water it down.

 Step VI
Basecoat the red and metal areas with Khorne Red and P3 Pig Iron.


Step VII
Highlight the red with Mephiston Red.

Step VIII
Wash all the metal areas with Quickshade Dark Tone or a similar black wash, then layer with P3 Cold Steel. I also took this chance to basecoat all the gold areas with P3 Molten Bronze.

Step IX
Wash the gold with Quickshade Strong Tone or a similar dark brown wash.


Step X
Highlight the gold with P3 Rhulic Gold.

Step XI
Basecoat all the under suit areas with Adeptus Battlegrey, or the new Eshin Grey.

Step XII
Highlight the under suit areas with Dawnstone.

The Chapter Symbol
Step XIII

Block out the sword with a t using Skull White. It’s important to make sure you get it roughly in the middle.

Step XIV
Make that t look like an actual sword.

Step XV
Add the wings to both sides. Don’t worry to much about mistakes, you can always fix those later.


Step XVI
Block out the feather parts of the wings. Again, don’t be afraid to clean up after your’e done.

Step XVII
Clean up the wings with some Caliban Green, making sure all the edges and nice and flat, and the wings line up with each other.

Eyes
Step XVIII
Basecoat the eyes with Mephiston Red. Try to be careful with these next steps, you don’t want to have to re paint that lovely face!

Step XIX
Highlight towards the edge of the eyes with a 1:1 mix of Mephiston Red and Blazing Orange (Not shown at the start, my bad).

Step XX
Take some Skull white and add small dots to the top edge of the eyes.

The Base
Step XXI
Basecoat with Rhinox Hide. Don’t be afraid to water it down, or use mulitple layers.

Step XXII
Drybrush with a 1:1 mix of Rhinox Hide and Bleached Bone.

Step XXIII
Drybrush with Bleached Bone, focusing towards the outer edges of the base.

Step XXIII (Shown below)
Give the base a wash of Quickshade Strong Tone or a similar dark brown wash.

And with that, you are done your Dark Angel Space Marine. Hopefully this helps a few of you finish those Dark Vengeance box sets, or inspires others to start an army of the Unforgiven.

Cheers.

15 Comments

  1. Avatar ADÈLE on June 2, 2013 at 8:13 am

    Damn this is awesome, thanks for an another tutorial.

  2. Avatar oakleys on June 4, 2013 at 11:13 am

    I’m usually to running around to blog to blog looking for tutorials and I’m really liking the layout and the amount of time you have put in to make this. Looking forward to more so I can stop running blog to blog and maybe have a central place to go. Tutorials I would like to see: A guide on how to start painting (for the noobs). How to paint white and how to paint black (Whatever chapters are fine with me). Thanks again.

    • Trysanna Trysanna on June 12, 2013 at 12:15 am

      I’m glad you like them! I have plans to push out a lot of tutorials. Hopefully one for every Legion.
      -Trysanna

  3. Avatar Louis on June 13, 2013 at 3:39 pm

    Thanks for the help painting the chapter symbol and the rest of the tutorial was a big help too.

  4. Avatar Leszek on June 17, 2013 at 1:13 am

    Very nice tutorial – especially since I’ve been eyeing that Dark Vengeance boxed set. I’m new to painting, but love Ultramarines. I wanted to paint the GW, but I’m a bit confused. Some tutorials use Macragge Blue as a base with their blue wash. After, the armor is cleaned up with Macragge again, followed by a highlight of Altdorf and a fine highlight of Calgar Blue. Other tutorials suggest cleaning the armor with Altdorf and just doing one fine highlight with Calgar. Any suggestions?

    • Trysanna Trysanna on June 17, 2013 at 10:21 am

      I find that starting with Macragge blue is often a little dark for my tastes. I would start with a base of Caledor Sky, then give it some broad highlights on the top areas with Hoeth Blue. Then highlight Fenrisian Grey, and put some watered down Kantor Blue in the recesses. I will see what I can do about a tutorial for the Ultramarines.
      -Trysanna

    • Avatar Leszek on June 18, 2013 at 3:43 am

      An Ultramarine tutorial would be great. They’re a classic which many people consider cheesy, but I think they’re amazing. Thanks for the color suggestions. I dont know why, but I didn’t consider Caledor Sky. Do you base with the standard “sand” approach? Have you tried the new texture paints from GW?

      • Trysanna Trysanna on June 18, 2013 at 10:13 am

        I have not gotten around to the texture paints, but it is on my list. At the moment, I have a small tub of sand that I use, and that seems to be working fine for me.
        -Trysanna

  5. Avatar Braedyn on September 8, 2013 at 8:44 pm

    Very nice tutorial you got going there. It helped a lot with my Dark angels and I am highly impressed with the chapter insignia and the eye lenses.

    • Trysanna Trysanna on September 8, 2013 at 9:45 pm

      Thanks. I’m glad to know it helped!
      -Trysanna

  6. Avatar Jaze on September 10, 2013 at 10:45 pm

    Love the green and well everything about this one. Still think salamanders are my fav. Whens your next tut going to be up? Please say it is going to be ultramarine’s, I need to see that one. – Jaze

    • Trysanna Trysanna on September 12, 2013 at 7:24 pm

      I was planning on doing a newer Blood Angel one for Space Hulk, then a Deathwing one, and see where it goes from there. Ultramarines are on my list tho!
      -Trysanna

  7. Avatar Utah Valley Model Painting on September 15, 2013 at 8:44 pm

    Awesome detailing. I do a few Warhammer 40K miniatures for the heck of it (mostly Dark Vengeance models), and I think it’s awesome how realistic (for a little painted thing of plastic) it is. Great job.

  8. Avatar shirlzknight on November 3, 2014 at 12:26 am

    Superb- I recently returned to W40K after almost a thirty year absence- got a lot of lore to catch up with! I Decided to build a Dark Angel army and I am just about to begin paionting them up. I have watched/read a load of tutorials on the subject but got to say this one stands out with it’s simplicity and aesthetics. I shall be referencing your guides from here on in- Thanks for taking the time to do these- Nice one 🙂

    • Fabalah Fabalah on December 28, 2014 at 2:25 pm

      I’m glad you found the tutorials helpful! We’ve got some plans to do a Deathwing and Ravenwing tutorial, but we will see what the future holds on that. Feel free to post some photos of your Dark Angels on our Facebook page, I’d love to see them.

Leave a Reply Cancel Reply